The command to launch the session is sudo screen /dev/ttyUSB0 38400, where 38400 is the baud rate. Once in communication with the on-board computer (which can take patience as it can be kind of slow), there are numerous commands you can send; they are mainly in the form of one or two 2-digit hexadecimal numbers: a mode which may be followed. HO2S 1 Heater Command: HO2S 2 Heater Command: Change Engine Oil Indicator Command: Low Engine Oil Pressure Indicator Command: Engine Oil Level Switch: Cold Startup: EVAP Vent Solenoid Command: Fuel Volatility: RVS Request Signal: Starter Relay Command: EC Ignition Relay Command: Ignition Accessory Signal: Crank Request Signal: Engine Load: Engine Oil Pressure Sensor.
Read through more
43total
4
2
Look at even more
February 3, 2019
1.9M
10,000+
1.7
4.1 and upward
Google Commerce Ltd
HANOI, 100000VIETNAM